4 Commonplace Electric Hot Water Heater Problems

Admin

Hot Water Heater

Your hot water system is one of the chief appliances in your home but is often taken for granted. Unless the system is turned off while on vacation, it generally is an appliance that is used every day, and it is likely that you’ll experience some issues with it at some point.

Luckily, tank-type water systems are fairly uncomplicated products. They only consist of a few components compared to other appliances, and some fixes can be done by yourself without breaking the bank. However, if you’re experiencing a problem with the water tank itself, it is necessary to have a new water heater installed.

Conventional Issues That A Homeowner May Experience With An Electric Hot Water System

1. Water Leaking From The Top Of The System

Water Leaking From The Top Of The System
If you notice water leaking near the top of your water heater, it could be due to a few issues. The hot outlet or cold inlet pipes may be loose, the T&P valve may be faulty, or the inlet valve on the system may leak. All of these are easily repaired.

2. Water Leaking From The Bottom Of The System

Water leaking from the bottom of an electric water heater usually happens due to regular condensation, an electric heating element gasket that has a leak or a small volume of water being released through the overflow pipe because the T&P valve opens to discharge excessive pressure in the water tank. It may also be a case of the actual tank leaking and you may need to call a plumber specializing in hot water heater repair NYC to replace the water heater.

3. No Hot Water Whatsoever

Generally, the water in your electric water heater gets heated in most cases by two heating elements. If you have no hot water, you may need to check your breaker box first to see it the circuit breaker has tripped. If this is not the case, then it’s possible that the heating elements are faulty and needs to be replaced. Another reason may be an issue with your limit/reset switch located on the thermostat. If the water is too hot, the switch may have tripped, or it is faulty and must be replaced.
No Hot Water Whatsoever

4. Not Adequate Hot Water

If your thermostat is failing, it may be the main cause for you not having enough hot water. Sometimes it is merely necessary to adjust the desired water temperature on your thermostat for a specific heating element. The thermostat on electric models is generally hidden behind a layer of insulation on the side of the tank. Contrasting to gas models, an electric thermostat is set at the factory and not projected to be replaced; however, sometimes it must be necessary to do so. During Winter it may be needed for you to raise your thermostat temperature as hot water cools down quicker when it is traveling through the pipes of your home’s plumbing which is generally cold in Winter. Other causes for not having enough hot water is a faulty element, a faulty thermostat, loose wiring, or a water tank which is too small to cater for your requirements.

4 Commonplace Electric Hot Water Heater Problems was last modified: by